Quadra-Fire CASTILEI-CE-MBK Indoor Fireplace User Manual


  Open as PDF
of 36
 
Page32
October 27, 2011
R
Castile & Santa Fe CE Insert
7069-101B
H. Surround and Cast Trim Set
(CASTILE INSERT)
Included in Surround Kit:(2)sidesurrounds,leftand
right;(1)surroundtop;(1)fastenerpackage.
Included in Cast Trim Kit:
(2)casttrimlegs,leftandright;(1)
casttrimheader;(2)casttrimfooters,leftandright
Tools Needed: Powered102mmto152mmPhillipshead
screwdriver
1. Removecontentsfromboxbeingcarefulnottoscratchor
damagethecasttrimpieces.
2. Laythesurroundsetfacedownonprotectivecoveringto
preventscratchingthepaintedsurface.
3. Usinga102mmto152mmlongPhillipsheadscrewdriverto
attachthesidesurroundstothetopsurroundusing(2)#8
sheetmetalscrewsoneachsideprovidedwiththekit.
4.
Placethepeelandstickroundfeltvibrationinsulationpadson
thefrontsideineachcornerofthetopmetalpieceandonthe
backsideineachcornerofthetopcastpiece.Figure 32.1.
5. Placethecorrespondingcasttrimpieces(2casttrimsides
and1casttrimheader)underneaththesurroundset,alsoface
down.Aligntheholesinthemetalpieceswiththe5bosses
onthetopcastpieceand2bossesoneachsidepiece.
6. Securethemagnettothebracketandattachthemagnetand
brackettoeachmetalsidepieceatthebottom.Themagnet
isfacingthefront.Figure 32.2.
7. Placethecastfootersunderthemetalsidesaligningthetop
andbottomholesinthecastfootersandmetalsides.
8. The9mountingclipsareshippedinonelongstrip.Hand
breakapartorusepliers.
9. Eachcliphasaclearancenotchtoallowroomforthecast
ontheinsert.Placetheclipsothenotchisfacingtheouter
edgesofthesurrounds.Figure 32.3.
10.Itisbesttoinstallallofthe1/4-20screwsonlyhalfwayat
rsttoallowforadjustments.Afteradjustment,tightenthe2
screwsineachcastfooterrstandthenworkyourwayaround
totherest.
11 Remove the cast sides before attaching the surround
andtrim.Liftupthetoptoexposethethumbscrewsat
thetopofcastside.Figure 32.4.
12.Remove the thumb screw and top bracket and then
removethecastside.Layitdownonasoftsurfaceto
avoidscratchingthecast.
13 Slidesurround andtrimoverthetopofthe insertinto
place.Surroundattachstoinsertatthetopandbottom
ofinsertside.Figure 32.4.
14.Re-install the cast sides and secure with the thumb
screws.
Donotpickupassembledappliancebycorners.
Itistooheavyandmaydamagethesurrounds.
Pickupfromcenter.
CAUTION
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnet
before installing
Cast Footers
Magnet Installed
Cast Footers,
Left & Right
Back
of
Side
Piece
Magnet Attached - Faces Front
Clearance Notch
Figure 32.2
Figure 32.3
Surround Set
attaches to top
and bottom of
insert sides.
Thumb
Screw
Bracket
Figure 32.1
Figure 32.4
 previous next