R
October 27, 2011
Page31
Castile & Santa Fe CE Insert
7069-101B
Base Plate Only Installation
Parts Needed:(1)castring(2)basezeroclearancepanel
extensions.Discardbalanceofparts.
Tools Needed: Phillipsheadscrewdriver
1. Attachbasezeroclearancepanelextensionstocast
ring.
2. Placeassemblyunderappliance.
Panel Extension
Panel Leg
Cast Trim Footer
Figure 34.1
Figure 34.4
G. Surround & Trim Set, Econo
(CASTILE INSERT)
1. Secure the top surround to the surround sides
withthescrewsprovided.Figure 34.2.
2. Assemble the trim with the (2) corner brackets
provided.Figure 34.3.
3. Slide the assembled trim over the assembled
surroundset.
4. Remove the cast sides before attaching the
surroundandtrim.Liftupthetoptoexposethe
thumb screws at the top of cast side. Figure
34.4.
5. Remove the thumb screw and top bracket and
thenremovethecastside.Layitdownonasoft
surfacetoavoidscratchingthecast.
6. Slidesurroundandtrimoverthetopoftheinsert
intoplace.Surroundattachstoinsertatthetop
andbottomofinsertside.Figure 34.4.
7. Re-install the cast sides and secure with the
thumbscrews.
Back of Top Panel
Back of Side Panel
Screws
Figure 34.2
Figure 34.3
View of "L" Bracket
installed
Thumb
Screw
Bracket
Surround Set
attaches to top
and bottom of
insert sides.
F. Hearth Support For Standard Surround (Cont’d)
Included in Surround & Trim Kit:
(2)cornerbracketsand
setscrews;(1)trimset,3piece;(2)sidesurrounds;(1)
topsurround;(4)screws;
Tools Needed:PoweredPhillipsheadscrewdriver