Filter
Top Products
16 C1621M-E (9/08)
2. Remove the rubber feet from the underside of the unit if they are attached.
3. Attach one front-mount rail to one rear-mount rail. Make sure the rails are mounted back to back, as shown in Figure 10. Depending on rack
depth, use either three or four 8-32 x 0.375-inch Phillips truss head screws for each rail set. Leave the screws loose until step 10.
Figure 10. Assembling a Support Rail
4. Repeat step 3 for the other rail set.
5. If you are installing the unit into a square-hole rack: Insert 14 cage nuts into the square-hole rack as shown in Figure 11. Align the bottom
cage nuts on the front racks with the bottom cage nuts on the rear racks. Then align the top cage nuts with the front racks as shown.
Figure 11. Inserting Cage Nuts
(4) SCREWS
8-32 X 0.375-INCH
PHILLIPS TRUSS HEAD
ALIGN
ALIGN
FRONT-MOUNT RACK REAR-MOUNT RACK
CAGE NUT
CAGE NUT