Filter
Top Products
38
Problem
Reclining does not take place even though a
massage is started in pre-programs.
(The seat does not automatically recline.)
In some cases the seat may not automatically recline
depending on the position (angle) of the backrest or
the legrest.
Cause and Remedy
The backrest does not return to the upright
position.
The backrest will not return to the upright position if
the timer is activated or the button is pressed.
(Pressing twice will return the backrest to its
original position.)
The legrest does not go down. The legrest will not go down properly if the legrest
slide has been extended. Try again after retracting it.
The unit has been damaged.
Stop using the unit immediately.
The power cord or power plug is abnormally
hot.
Stop using the unit immediately.
The arm massage does not work. • The power cord has been disconnected.
(See Page 11)
• The power switch on the unit has not been turned on.
(See Page 11)
• A Pre-Program button or Manual Operation button
hasn’t been pressed after pressing .
(See Pages 15, 21, 27, 33)
• The air plug is not properly connected or disconnected.
(See Page 9)
The unit will not operate at all.
• Upper body (neck to lower back) massage.
• Lower body (calves to seat) massage.
• The power cord has been disconnected.
(See Page 11)
• The power switch on the unit has not been turned on.
(See Page 11)
• A Pre-Program button or Manual Operation button
hasn’t been pressed after pressing .
(See Pages 11, 15, 19, 22, 25)