Filter
Top Products
Thinner
Benzine
Alcohol
35
CAUTION
• Always unplug the unit before cleaning it. Never touch a power plug with wet hands.
Failure to follow these instructions may lead to electrocution or burns.
CAUTION
• Do not move the unit while someone is seated on it. Do not place objects on or sit, climb, or stand on
the legrest.
• When moving the unit using the wheels, remove all obstacles from around it, make sure the backrest is
in the upright position, lift it no higher than waist height (no higher than 31 in. (80 cm)) and roll it slowly.
Failure to do so may cause the unit to tip over, which may lead to damage or injury.
CLEANING AND MAINTENANCE
• Wipe these areas with a soft, dry cloth. (Do NOT
use cloths containing any kind of chemical, etc.)
• If the synthetic leather is particularly dirty, soak a soft
cloth in water or a 3~5% solution of mild detergent,
wring it out thoroughly and tap the surface with it.
Next, rinse the cloth in water, wring it out
thoroughly and then wipe any remaining detergent
from the surface, wipe the surfaces with a soft dry
cloth and allow them to dry naturally.
(Do NOT use a hair dryer to try to dry the surfaces
more quickly.)
• Do not allow these areas to come in contact with
plastic for extended periods of time as this may
lead to discoloration.
Areas Covered with Synthetic Leather
Lifting the Unit Using the Wheels to Move the Unit
Pipe and Plastic Areas
Moving the Unit
(1) Wipe the unit with a cloth that has
been soaked in a mild detergent and
then thoroughly wrung out.
(2) Next wipe the unit with a cloth that
has been moistened with just water
and thoroughly wrung out.
* Make sure you thoroughly wring out
the cloth first when cleaning the
control panel.
(3) Allow the unit to dry naturally.
• Please do NOT use thinners, benzine
or alcohol.
Seat Fabric
(1) Wipe the seat fabric with a cloth that
has been soaked in a mild detergent
and then thoroughly wrung out.
(2) Use a mild detergent and brush on
areas where the seat fabric has
become particularly soiled. Be careful
not to brush the fabric too much as
you may damage it.
(3) Next wipe the fabric with a cloth that
has been moistened with just water
and thoroughly wrung out.
(4) Allow the fabric to dry naturally.
• Move the chair by having one person hold onto the rubber
section on the underside of the legrest and another person
use the handle on the back of the backrest.
* Please hold the handle and legrest securely to avoid dropping
the unit as it may damage your floor.
• Move the chair by holding onto the rubber section on the
underside of the legrest and using the wheels.
(It is easier to move the unit when the massage heads are
positioned at the top of the backrest.)
* Place a mat on the floor and gently roll the unit over it to avoid
damaging the floor.
Mat Mat WheelsPlace your fingers in the groove.
Make sure the legrest is
retracted to the minimum length.
Make sure the legrest is
retracted to the minimum length.
Place the control
panel on the seat.
Place the control
panel on the seat.
Hold onto the rubber section on
the underside of the legrest.
Do not hold onto the fabric.
Hold onto the rubber section
on the underside of the legrest.
Do not hold onto the fabric.
Roll the unit
slowly.
Rubber Section
Handle
Rubber Section
Water
Mild Detergent
Mild Detergent
Water
Water