Filter
Top Products
8
Ensure there is adequate space for reclining.
Mat
Handle
Place your fingers in the groove.
Legrest
Rubber
Section
Area where legrest
could touch floor.
Area where unit touches floor.
Keep at least
4" (10 cm)
away from
wall, etc.
Keep at least
4" (10 cm)
away from
wall, etc.
Mat
Approx. 14"
(35 cm)
Approx. 77" (195 cm)
Width approx. 27" (68 cm)
(approx. 33" (84 cm) with
armrests attached)
Approx. 12"
(30 cm)
Front Back
Connector Hose
Air Plug
(Cross-section)
BEFORE USING THE UNIT
SETTING UP THE MASSAGE LOUNGER
After Removing Everything from the Box, You Should Have the Following
Where to Use the Unit
Armrests
Marks indicating left and right can be found
on the underside of each armrest.
Pillow
Control Panel Stand
Attachment Screws (M6#16) — 6
Left Armrest — 3
Right Armrest — 3
Control Panel Stand Attachment Screws
(M6#10) — 4
Plug Cover Attachment Screws
(M5#16) — 2
Plug Covers — 2
Allen Key — 1
Control Panel
Stand Covers
Lock Switch Keys — 2
Massage Lounger Accessories
Small holes on the inside
fabric are an intentional part
of the functional design.
CAUTION
• Do not use the unit in areas with high humidity,
such as the bathroom, etc. as this can lead to
electric shock or other accidents.
• Place the unit on a totally flat surface.
Failure to do so may result in the seat tipping over.
• Do not use the massage lounger in direct sunlight or in
places where it will be exposed to high temperatures,
such as in front of a heater, etc., as this can cause
discoloration or hardening of the synthetic leather.
• Place the unit on a mat to prevent floor damage.
• When placing a mat under the unit, the size of the mat
should be sufficient (at least 47#28 in. (120#70 cm)) to
cover the areas where the unit touches and the legrest
could touch the floor, as shown in the diagram on the left.
Move the chair by having one person hold onto the rubber
section on the underside of the legrest and another person
use the handle on the back of the backrest.
Carrying in the Unit
CAUTION
• Make certain the legrest has been retracted fully
to its original length.
Failure to observe this safeguard could result in injury
due to the legrest returning to its original length
when the unit is being moved.
• Use care to prevent pinching of hands or feet when letting
go of the legrest as its mechanism will cause it to slam shut.
• Use care to prevent lower back and other injuries that
could occur when lifting this heavy object (approx. 179
lbs (81 kg)).
0.2"
(4 mm)
Clip