Filter
Top Products
DATA-LINC GROUP
38
PN 161-09981-002C
rev 8/04
DDAA1000/SRM User Guide
To back out of the process and not enable the password, hit escape. To set a password, type in exactly 4 characters. At any
point in the process you can cancel by hitting the escape key. Once the 4 characters have been entered, you will be
prompted with “<enter> to accept, <esc> to quit”.
At this point, if you wish to accept the password entered and enable the feature, press the enter key. The password that you
have chosen is displayed on the line above (please note that the password is case sensitive). To quit the process and not
enable the password, press escape.
Changing a Password
Once the password feature has been enabled, it is possible to change to a new password. To enter a new password select
(8) from the Main Menu. You will be prompted with “Enter Security Code”. Enter the current password. Once the password
has been entered correctly (it is case sensitive) you will be prompted to enter the new password. At any point this process
may be cancelled by pressing escape.
Disabling Password
The process to disable the password is similar to the process to change the password. However, when prompted to enter the
new password, the following procedure needs to be followed:
1. Hold the “Alt” key down and using the number key pad (not the numbers across the top of the keyboard)
type “0255”
2. Release the “Alt” key
3. Repeat steps 1 and 2 three more times (this will enter 0255 a total of four times).
4. You will be prompted with “<Enter> to accept, <esc> to quit.
5. Hit the “Enter” key to disable the password or hit the escape key to keep the password