Filter
Top Products
6-10
Table 6-2 (cont’d) FLOW RATE MODE
KEY DISPLAY ACTION TAKEN
SHOWS AND PROCEDURE
TIME
FLOW
RATE
xx:xx:xx
Displays cumulative TIME
since start
Press the TIME key. The display flashes the time that the pump has
been running (xx:xx:xx).
xxx mL/min
or
xxx L/min
Displays current FLOW
RATE setting
1. Press the FLOW RATE key. The display flashes the flow rate
setting you selected just before starting the pump.
2. Use the UP and DOWN ARROW keys to enter the FLOW
RATE setting you desire. As you use the UP and DOWN
ARROW keys, the display changes accordingly. Refer to
Figure 6-4.
TOTAL
VOLUME
TUBE ID
xxx mL/min
or
xxx Liters
Displays current TOTAL VOLUME
Press the TOTAL VOLUME key. The display flashes the calculated
volume of fluid dispensed since the pump started running (xxx mL or
xxx Liters).
TUBE ID=xxx
Displays current TUBE ID
Press the TUBE ID key. If the red LED next to the CALIBRATE key
is not lit, the display flashes the current TUBE ID setting. If the red
LED next to the CALIBRATE key is lit, the display flashes the
message “CALIBRATED TUBE!”.
CALIBRATE
CALIBRATED!
or
not calibrated
Displays calibration state
1. Press the CALIBRATE key. If the red LED next to the
CALIBRATE key is not lit, the display shows “not calibrated”..
If the red LED next to the CALIBRATE key is lit, the display
shows “CALIBRATED!”.
To calibrate a tube:
2. Press the START/STOP key to stop the pump. The display
returns to the STOPPED Display Mode. For detailed instruc-
tions on “Calibrating a Tube”, refer to Section 5.5.
ᮡ and ᮢ
xxx mL/min
or
xxx L/min
NOTE: if you press the UP and DOWN ARROW keys, the display
shows the current FLOW RATE setting. This setting
changes accordingly as you use the UP and DOWN
ARROW keys but does not wrap around at maximum and
minimum values while the pump is running.
NOTE: if you press the Language button, the display changes to
the next language in the sequence: English, French,
Spanish, German, and Italian.
Language
Button