Filter
Top Products
6-9
Table 6-2 FLOW RATE MODE
KEY DISPLAY ACTION TAKEN
SHOWS AND PROCEDURE
XXX mL/min
or
XXX L/min
Pump motor’s power
NOTE: if you turn off the pump motor’s power, the pump stops
running.
To continue pumping, turn on the unit’s power. The display
returns to the STOPPED Display Mode and shows the current
FLOW RATE setting. The accumulated time of pumping and
volume dispensed is reset to zero. Then press the START/STOP
key .
XXX mL/min
or
XXX L/min
Pump(s) starts; press again pump(s) stops
To start pumping at this setting, press the START/STOP key.
The display enters the RUNNING Display Mode, and the fluid
begins to dispense.
START
STOP
ON/OFF Switch
Must STOP first!
LEDs indicate new pump direction
To select the other inlet and reverse the direction of pumping:
1. Press the START/STOP key. The display returns to the
STOPPED Display Mode.
2. Press the INLET SELECT key to reverse the direction of
pumping.
3. Press the START/STOP key again to resume pumping.
4. For detailed instructions on “Defining the Direction of
Pumping, refer to Section 5.2.
INLET
SELECT
STOP to Prime...
Pumps fluid at current flow rate
setting as long as the key is pressed
To prime a tube:
1. Press the START/STOP key to stop the pump. The display
returns to the STOPPED Display Mode.
2. Press and hold down the PRIME key to prime the tube.
3. Press the START/STOP key again to resume pumping.
4. For detailed instructions on “Priming a Tube”, refer to
Section 5.4.
PRIME
xxx °C
Display alternates when pressed, °C then °F
NOTE: The TEMP key functions the same whether the pump is
stopped or running. Refer to Section 5.6.
TEMP
RPM
xxx rpm
Displays actual RPM
Press the RPM key. The display flashes the actual pump motor
speed (xxx rpm).