Filter
Top Products
1. Press the TUBE ID key. The display shows the last TUBE ID setting used, in
inches or millimeters. Table 5-2 lists all the pre-programmed tubing inner
diameters.
2. Use the UP and DOWN ARROW keys to enter a TUBE ID on the display. Once
you start the pump motor, after selecting a mode (refer to Chapter 6), the pump
will dispense fluid at a flow rate calculated based on the last TUBE ID displayed
before the pump starts to run.
If the red LED next to the CALIBRATE key is lit, the pump motor is running
according to the last calibration complete (refer to Section 5.5).
If you press the TUBE ID key while the red LED is lit, the display shows
“CALIBRATED TUBE!”.
Table 5-2. Tube Inner Diameters
Tube Inner Diameters
English Metric
1
⁄32" 1.0 mm
1
⁄16" 2.0 mm
1
⁄8" 3.0 mm
3
⁄16" 4.0 mm
1
⁄4" 5.0 mm
5
⁄16" 6.0 mm
7.0 mm
8.0 mm
Operating the Pump Motor in the STOPPED Display Mode
5
5-5
TUBE ID = XXX
TUBE ID
ACTION
Displays current
TUBE ID
Display shows
Using the UP ARROW key (
ᮡ
) will cause the TUBE ID value to scroll up through
the available choices.
Using the DOWN ARROW key (ᮢ) will cause the TUBE ID value to scroll down
through the available choices.
OR
NOTE