Filter
Top Products
Section 9, Installing the Distribution Module
• The Distribution Module is connected to the Distribution
Module Zone Control Board through the electrical connections
located at the bottom of the Zone Control Board box. The
distance apart is dictated by the length of the 9 pin connector
cord used.
9.4 Plumbing Installation
The plumbing installation should consider the following:
• The Distribution Module, see Figure 9-3: Distribution
Module Fittings Location. See the illustration for the location
of the fittings.
Figure 9-3: Distribution Module Fittings Location.
All fittings on the Oasis™ Distribution Module require two
wrenches when tightening. One wrench must be placed on the
module fitting and held in place to prevent this fitting from being
overstressed. The other wrench can be used to tighten the
matching half of the fitting onto it. Failure to follow this
procedure will damage the Oasis™ Distribution Module, and the
fittings.
NOTICE
International Thermal Research 9-3