Filter
Top Products
Section 9, Installing the Distribution Module
• Module must be mounted using four, 1/4” through bolts using
1” diameter fender washers, lock washers and nuts. The
module must be mounted in the position as shown against a
wall or on the floor.
Figure 9-1: Distribution Module, DM12
9.3 Selecting the Distribution Module
Zone Box Location
• Mount the Distribution Module Zone Box (containing the
Zone Control Board) vertically, close to the Distribution
Module. Allow sufficient room to access the internal fuses as
well as to view the display LED’s on the board itself.
• Mount the bracket against a wall using 2 flat head screws.
The distribution module zone box will then click onto the
bracket.
Figure 9-2: Distribution Module Zone Box
9-2 The Oasis™ Heating Module