Freedom F-64 Installation Instructions
L NAPCO Security Systems
WI1501A 9/06
Page 10
TESTING THE SYSTEM
After installation is completed, test the system as follows.
1. Call the central station to inform them of the test.
2. Initiate an alarm, preferably on a zone that activates a steady siren, and verify proper signalling.
3. Call the central station to confirm their receipt of a good transmission.
Note: Be sure to test all enabled Touchpad panics.
Signal Strength Testing/Wireless Systems
To test the operation of wireless transmitters, proceed as follows.
1. Enter the Fault-Find mode. (See Touchpad Menu Mode in WI1502. Panel must be disarmed).
2. Fault a point of the transmitter to be tested by opening the loop. If the signal strength of the
transmitter is 3 or greater, the Touchpad will beep, as follows:
3. Restore the wireless point (close the loop).
The transmitter signal strength will be displayed on a scale of 3-10 with 3 considered marginal and 10
considered excellent. Note that if the signal strength is less than 3, the Touchpad will not beep and the
strength will not be displayed. Except in the Fault-Find mode, signal strengths less than 3 will be entered
into the system log. Upon zone restore, the Touchpad will beep once.
Signal Power Beeps
0-2 0
3 1
4-5 2
6-7 3
8-10 4
Testing the System