Filter
Top Products
CDVSC7 & CDV7 Series Gas Fireplace
46
69D3011
1. Remove upper and lower louvers.
. Release the clamps on the bottom of the fireplace.
Figure 61
3. Tilt glass frame out and lift glass frame up until it clears
the hook on top of the frame.
4. Set glass frame aside.
1. For best results in flame appearance and opera-
tion, use one (1) 8 gram bag of rock wool for
propane/LP models and up to three (3) bags of
rock wool for natural gas models.
. Pull the rock wool apart into dime-sized pieces
or smaller. Cover the entire surface of the burner
with one thin layer of rock wool.
3. Place the logs on the burner. Refer to the “Log
Placement Section”. Light the unit and after 15
minutes check burner flame and glow. Adjust
embers as necessary to achieve an even and
clean flame.
FP2297
remove glass
Figure 61 -
Removing Glass Frame - CDVR Series Shown
Glass Frame
Clamps -
on 33/36 Models,
3 on 4/47 Models
FP97
FP2648
BDV rock wool place
Figure 62 - Placement of Rock
Wool on Burner
Cover with
Rock Wool
Burner
FP648
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.