Filter
Top Products
20
5-1-2 Setting the Mail Server Information
Enter the mail server information provided by either the ISP or
the LAN administrator.
Either the IP address or the host name (server name) can be
entered in the mail server field.
Make necessary settings depending on the functions to be used, using the table below as a reference.
Table 5-2 Items that Require Settings to Be Made (Mail Server Information)
Error Mail Report Mail Communication
Functions
Items
No SMTP
Authentication
Uses SMTP
Authentication
No SMTP
Authentication
Uses SMTP
Authentication
Outgoing Mail Server (SMTP)
V
IP Address or
Host Name
V
Host Name
V
IP Address or
Host Name
V
Host Name
SMTP Authentication V V
Incoming Mail Server (POP3)
V
IP Address or
Host Name
V
IP Address or
Host Name
DNS Server (Primary)
(V)
*1
V
(V)
*1
V
DNS Server (Secondary)
(V)
*1
V
(V)
*1
V
*1: Not necessary if the IP address is used as the mail server address.
5-1-3 Setting the Error Mail Destinations
(1) Enter the title of the error mail that will be sent from GB-24A
in the [Mail Title] field. The title may contain a maximum of
40 characters.
Note: The following characters cannot be used in the mail title:
< > & “ ‘
(2) Choose the error type out of the following: [Unit Error], [Preliminary Unit Error], [Communication Error],
[General Equipment] and [User Setting 1] through [User Setting 6]. Then enter the mail address of the
recipient of the error mail.
(3) To send error messages only upon occurrences of certain
errors, click the User Setting button that appear when "User
Setting 1" through "User Setting 6" are selected, and
register the error codes to be reported in the user settings.
A maximum of 20 error codes can be set for each user
setting. In addition to specific error codes such as [1302] or
[6607], codes such as [10**] or [12**] can also be used. If
[10**] is set, for example, error mail will be sent upon an
occurrence of any type of errors between [1000] and [1099].
If error codes are set on this screen, confirm that the
address of the recipient is registered.
(4) Do not select "General Equipment."