-20-
• Follow the procedures described below to set each daily schedule pattern for each group.
• The setting temperature or set-back values setting are also performed in the schedule setting operation. To enter
the setting temperature or set-back value setting select SET-BACK or SET TEMP. Accordance with section "5-7
user setting (page 34)" in advance.
• The setting temperature or set-back value selected in this way take effect only during timer operation.Also set-
back operation is cancelled if the setting temperature is changed using this central controller or a local remote
controller.
( The set-back operation resumes at the next timer-ON time )
Press the switch to display the group in desired a timer
Press the switch to move the cursor position to
the pattern ( P1 P3, P4 ) to be setting.
Press the switch one time.
The schedule pattern setting screen is displayed.
Press the switch to move the cursor position to
the first ON (PROHIBITION) time.
Press the switch to select the ON (PROHIBITION)
/
time. (time is changed by 10 minutes unit.)
Press the switch one time to set ON (PROHIBITION) schedule.
(The cursor moves to the next setting position.)
Perform operation to select OFF (PERMISSION) time.
Perform operation to set the OFF (PERMISSION) time.
Repeat operation to to set the second and third ON/OFF (PRO-
HIBITION/PERMISSION) schedules in the same manner.
When the second or third ON/OFF (PROHIBITION/PERMISSION) sch-
edule is not used, the characters " " remain display and press
:
the switch one time.
To cancel the ON/OFF (PROHIBITION/PERMISSION) time that was set
previously, use the switch to move the cursor
to the time position to be cancelled and press the switch.
When the P1 setting are completed,perform operation to as nec-
essary to perform the setting for P2 or P3 or P4 .
Setting example in case of P4
setting.
(1) Schedule pattern (P1 P3) setting
<Schedule pattern setting( P1 P3, P4 ) >
5
CLOCK / PATTERN
8
GROUP
SELECT
ENTER
ENTER
ENTER
1
2
2
3
4
5
6
6
6
7
7
8
9
9
10
11
11
12
DEL.
RESET