Filter
Top Products
-16-
4 - 2 - 2 Collective operation setting
(1) Collective operation setting
• A collective operation setting and a collective prohibit setting can be performed for all the group managed by
this controller at one time.
Press the switch to set "COL. (COLLECTIVE)" in blinking
display and press the switch on the group operation setting
screen.
The collective operation setting initial screen is displayed.
Select the items for operation setting on the collective operation setting
initial screen.
The operation method is same as described in section "4-2-1 Group
operation setting" (Page 12).
The items which were not set, remain set to the same
condition that were set before the collective operation was
performed.
The items selected for the operation blink on the collective operation
setting screen.
When all setting are completed, press the switch to display
the "SET" in blinking display for the indicated function area.
Press the switch one time to complete this setting.
The collective setting is executed.
The collective setting takes approximately 20
seconds.
The display of setting contents is erased
when shift to another screen.
The collective setting is completed when the previous
items light. (After the setting are completed, start
from step to perform operation again if change
operation are required.)
NOTE:
NOTE:
ENTER
ENTER
1
2
3
3
4
5
6