Filter
Top Products
39
SYSTEM REPORTING CODES
✦ Refer to the System Reporting Codes table to
view/edit the reporting codes for the keypad FIRE
and EMERGENCY buttons and for each of the
four Console conditions. The factory settings are
listed, along with a blank area to write in the new
installation values.
STEPS #261-266
Any value from 0-99 can be programmed for each
event using these steps (enter “0” to stop an event
from reporting).
FORCE ARMING REPORTING CODE
✦ The factory set reporting code for force arming is
“65” (Code 574 with Ademco).
STEP #258 Any value from 0-99 can be programmed for this
event using this step (0 = no report).
✎ NOTE: For force arming reporting, force arming
reports must be enabled. See Page 37.
DURESS REPORTING CODE
✦ The factory set reporting code for Duress is “66”
(Code 121 with Ademco).
STEP #259 Any value from 0-99 can be programmed for this
event using this step (0 = no report).
✎ NOTE: For duress code reporting a keypad duress
code must be programmed. See Page 30
.
Opening & Closing Reporting Codes Table
System Reporting Codes Table
SYSTEM REPORTING CODES
STEP # PROGRAMMING FUNCTION
POSSIBLE
4 BY 2 VALUES
FACTORY
4 BY 2 VALUES
ADEMCO VALUE
INSTALLATION
4 BY 2 VALUE
258 FORCE ARMING REPORT CODE 0 - 99 65 574
259 DURESS REPORT CODE 0 - 99 66 121
261 SYSTEM FIRE REPORT CODE 0 - 99 68 110
262 SYSTEM EMERGENCY REPORT CODE 0 - 99 69 120
263 SYSTEM TEST/CANCEL REPORT CODE 0 - 99 70 406
264 SYSTEM LOW BATTERY RESTORAL REPORT CODE 0 - 99 71 R302
265 SYSTEM LOW BATTERY CODE 0 - 99 73 E302
OPENING & CLOSING REPORTING CODES TABLE
USER CODE
4 x 2 CLOSING
(ARMING) CODE
4 x 2 OPENING
(DISARMING) CODE
ADEMCO CLOSING
(ARMING) CODE
ADEMCO OPENING
(DISARMING) CODE
MASTER USER CODE1 74 82 R401 C000 E401 C000
RESTRICTED USER CODE #1 75 83 R401 C001 E401 C001
RESTRICTED USER CODE #2 76 84 R401 C002 E401 C002
RESTRICTED USER CODE #3 77 85 R401 C003 E401 C003
RESTRICTED USER CODE #4 78 86 R401 C004 E401 C004
RESTRICTED USER CODE #5 79 87 R401 C005 E401 C005
PAGE ALERT USER CODE (DIALS PAGE NUMBER ONLY, NO CODES REPORTED)
REMOTE ARM & QUICK ARM 81 R407 C007
REMOTE DISARM 89 E407 C007
6
MNO
0 - 99 FOR CONSOLE
REPORTING CODE
PROGRAMMING STEPS
#261 TO #266
PROGRAM
STORE PROGRAM
2
ABC
5
JKL
8
TUV
0 - 99 FOR FORCE ARMING
REPORTING CODE
PROGRAMMING STEP #258
PROGRAM
STORE PROGRAM
2
ABC
9
WXY
0 - 99 FOR DURESS CODE
PROGRAMMING STEP #259
PROGRAM
STORE PROGRAM
2
ABC