Filter
Top Products
13
PROGRAMMING DIFFERENT SENSOR TYPES
✦ Follow the instructions on the previous page to
select a sensor number to program the sensor into.
✎ NOTE: A sensor can be programmed into more
than one location. Be sure to choose an UNUSED
sensor number. If a sensor gets entered into more
than one location, delete the duplicates using the
remove sensor function.
✦ To add DXS-10 wireless keypads, press and hold the
keypad's
key until programmed into the Console.
✦ For DXS-31 and DXS-32 door/window sensors,
move the magnet away from the side of the sensor.
✎ IMPORTANT NOTE: The DXS-31 & DXS-32 door/
window sensors are pre-set at the factory for
delayed burglary response. If the sensor is going
to be used on a non-entry portal (window, sliding
glass door, etc.) a jumper can be changed in the
sensor to select instant response. The jumper
should be changed before programming the
sensor so the Console will assign the sensor to
the proper sensor function. See the “Basic Sensor
Installation” section of this manual or the sensor’s
instructions for details on changing the jumper.
✦ For DXS-81, DXS-91, DXS-54, & DXS-73
accessory sensors, simply send a test transmission
(refer to the sensor's instructions for details on
sending a test transmission).
✦ For DXT-61, DXT-21, DXS-21, DXT-41, & DXS-62A
single-button remotes, simply press the unit's button.
✎ NOTE: After the Console recognizes the
transmitter, single-button remotes must be
re-programmed as “panic buttons” or home
automation controllers. Refer to the “Customizing
the System” section of this manual.
✦ For DXT-23, DXS-23, & DXT-42 multi-button
remotes: Learn the transmitter by pressing the left
button. The remote will arm the Console with the left
button and disarm with the right button. Labels are
provided with the DXT-42 for identifying the buttons.
✎ NOTE: After the Console “learns” the transmitter,
multi-button remotes can easily be re-programmed
to have the left button arm/disarm the Console
and the right button activate/deactivate the Home
Automation output. Refer to the “Advanced
Programming” section of this manual.
For All Models:
✴ A single “Bing” tone will sound and the sensor status
indicator will stay lit when the sensor is programmed into the
Console.
✴ A “Buzz” tone will sound if there is already another sensor
programmed to that sensor number.
✦ Exit Setup Mode by pressing the
key then press
OFF for three seconds. Reminder: The Console will
automatically exit the Setup Mode and return to Off
Mode after three minutes of keypad inactivity.
✎ NOTE: To remove sensors from the Control Panel's
memory, see the “Customizing the System”
section of this manual.
SEND SIGNAL WITH LEFT BUTTON
LEFT = ARM/DISARM
RIGHT = AUTOMATION