Filter
Top Products
30
AUTOMATION OUTPUT WHILE ARMED
✦ The factory setting causes the Console's
Automation Output to activate when pressing the
key, or when it's triggered with a two-button
remote control.
STEP #73 The Console can be programmed to activate the
Automation Output when the system is armed as
well as when normally triggered using this step.
AUTOMATION OUTPUT DURING EXIT/ENTRY DELAYS
✦ The factory setting causes the Console's
Automation Output to activate when pressing the
key, or when it's triggered with a two-button
remote control.
STEP #74 The Console can be programmed to activate the
Automation Output during the exit and Entry Delays
as well as when normally triggered using this step.
AUTOMATION OUTPUT POLARITY
✦ The factory setting causes the Console's
Automation Output to provide a current limited
voltage source when activated.
STEP #75 The Console can be programmed so the
Automation Output provides a current limited
voltage source when deactivated using this step.
REMOTE ACCESS PASSWORD
✦ This password is used to gain access to the Console
when using the RA-2400 remote access software.
The password must be 6-digits long.
STEP #87 Use this step to enter a new remote access
password then log the password in the box below.
DURESS CODE
✦ The duress code will disarm the system, without
any special indications or sounds, but will send the
programmed duress code to the Central Station.
The code should be two or more digits different
than any user code
STEP #92 Use this step to enter the duress code then log the
code in the box below.
MASTER USER CODE
✦ The master user code is 1234 when power is fi rst
applied to the Console.
✦ The master user code can be changed to any 1-5
digit code. Only the master user can access Setup
Mode, restricted users cannot.
✎ NOTE: For maximum security, a 3-5 digit code is
recommended.
STEP #99 Use this step to enter the new master user code
then log the code in the box below.
REMOTE ACCESS PASSWORD:
DURESS CODE:
MASTER USER CODE:
7
PRS
3
DEF
HOME
AWAY
PROGRAMMING STEP #73
PROGRAM
STORE PROGRAM
0 FOR STANDARD TRIGGER
1 FOR OUTPUT WHEN ARMED
7
PRS
4
GHI
HOME
AWAY
PROGRAMMING STEP #74
PROGRAM
STORE PROGRAM
0 FOR STANDARD TRIGGER
1 FOR OUTPUT DURING
EXIT/ENTRY DELAYS
7
PRS
5
JKL
HOME
AWAY
PROGRAMMING STEP #75
PROGRAM
STORE PROGRAM
0 FOR VOLTAGE WHEN OFF
1 FOR VOLTAGE WHEN ON
8
TUV
7
PRS
HOME
AWAY
PROGRAMMING STEP #87
PROGRAM
STORE PROGRAM
6-DIGIT REMOTE
ACCESS PASSWORD
9
WXY
2
ABC
HOME
AWAY
PROGRAMMING STEP #92
PROGRAM
STORE PROGRAM
1-5 DIGIT DURESS CODE
(3-5 DIGITS RECOMMENDED)
9
WXY
9
WXY
HOME
AWAY
PROGRAMMING STEP #99
PROGRAM
STORE PROGRAM
1-5 DIGIT MASTER CODE
(3-5 DIGITS RECOMMENDED)