Kul KU32085 Air Conditioner User Manual


 
INSTALLATION INSTRUCTIONS
11
Installation in a sliding sash windows
1. Cut the foam seal(adhesive type) to the proper length and
attach it to the window frame. See Fig.14.
2. Attach the window slider kit to the window stool.Adjust the
length of the window slider kit according to the width of
window, short the adjustable window kit if the width of
window is less than 27 inches.
Open the window sash and place the window slider kit on
the window stile. See Fig.15.
3. Cut the foam seal(adhesive type) to the proper length
and attach it on the top of the window. Show as in Fig.16.
4. Close the sliding sash securely against the window.
5. Cut the foam seal to an appropriate length and sealing the
open gap between the top window sash and outer window
sash. Show as in Fig.17.
Foamseal
FoamsealA
(adhesivetype)
Fig.14
Fig.15
Fig.16
Fig.17
Window
panel
26.5 ~ 48
11 ENGLISH
INSTRUCCIONES DE INSTALACIÓN
Empaquetadura de
espuma A
(tipo adhesivo)
Panel de la
ventana
Empaquetadura
de espuma
Instalación en ventanas con basti-
dores deslizables
1. Corte la empaquetadura de espuma
(tipo adhesivo) según la longitud nec-
esaria y adhiérala al marco de la ventana.
Véase la gura 14.
2. Coloque el deslizador para ventana en
el marco de la ventana. Regule la longitud
del deslizador de acuerdo al ancho de la
ventana. Acorte el deslizador si el ancho
de la ventana es menor a 27 pulgadas.
Abra el bastidor de la ventana y coloque
el deslizador sobre el marco. Véase la
gura 15.
3. Corte la empaquetadura de espuma
(tipo adhesivo) según la longitud nec-
esaria y adhiérala a la parte superior de la
ventana. Véase la gura 16.
4. Cierre el bastidor deslizable de manera
que quede asegurado.
5. Corte la empaquetadura de espuma
según la longitud necesaria y selle el es-
pacio entre la parte superior del bastidor
de la ventana y el bastidor externo de la
ventana. Véase la gura 17.
11 ESPAÑOL