Kenmore 790.479 Home Security System User Manual


 
Oven Vent and Racks
Upper Oven
Vent Location
Lower Oven
Vent Location
Some models are equipped with a blower which runs in baking
and self=cleaning mode to keep all internal components at a cool temperature.
The blower may keep running even if the oven has been turned off, until the
components have cooled down. On 30" double wall ovens, the blower in both
ovens will start when using one of the ovens in self-clean mode.
Oven Vent Location
Each oven is vented at its upper front frame. When the oven is on, warm air is
released through the vent. This venting is necessary for proper air circulation in the oven
and good baking results.
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN
IS COOL (PRIOR TO OPERA TING THE OVEN). Always
use oven mitts when using the oven.
@
To remove an oven rack, pull the rack forward until it
stops. Lift up front of rack and slide out.
To replace an oven rack, fit the rack onto the guides on
the oven walls. Tilt the front of the rack upward and slide
the rack back into place.
Air Circulation in the Oven
If using 1 rack, place in center of oven. If using multiple racks, stagger
cookware as shown.
iii..........
For best air circulation and baking results allow 2-4" (5-10 cm) around the
cookware for proper air circulation and be sure pans and cookware do not
touch each other, the oven door, sides or back of the oven cavity. The hot air
must circulate around the pans and cookware in the oven for even heat to
reach around the food.
1 Oven Rack
Multiple Oven Racks