Filter
Top Products
SECTION 3 CARE OF YOUR SOFTENER
, i1,1 ul, iiii ,,11,,i
3C. KEEP THE SOFTENER FROM FREEZING
u Ulll. ii,
If the softener is installed where it could fi-eeze
(summer cabin, lake home, etc_), you must drain
all water from it to stop possible freeze damage,
To drain the softener:
1. Close the shut-off valve on the house main
water pipe, near the water meter or pressure
tank_
2. Open a faucet in the soft water pipes to vent
pressure in the softener
m
If a single bypass valve is insta!led, move the
stem into bypass. See FIG, 12 on page 18 In a
3-valve bypass system, close the inlet and
outlet valve and open the bypass valve, If you
want water in the house pipes again, reopen
the shut-off valve on the main water' pipe,
4. Unplug the transformer at the wall outlet.
5. Remove the salt hole cover and the main
cover_ Take off both drain hoses
6. Careful!y remove the large holding clips at the
softener" inlet and outlet (see Key No, 61, on
page 30) Separate the softener fi'om the
adaptors or bypass valve
.
Remove the brinewell cover and disconnect
the brine valve tubing at the nozzle and venturi
assembly (see page 23), Lift the brine valve out
of the brinewell Tip the brine valve upside
down to drain out water.
DRAIN WATER FROM THE
SOFTENER
___..___---.----
Drain Wood Block
o
Q
Looking at FIG 11, lay a piece of 2 inch thick
board near the floor drain Move the softener
close to the drain. Slowly and carefully, tip it
over until the rim rests on the wood block with
the inlet and outlet over the drain Do not
allow the softener's weight to rest on the
inlet and outlet fittings or they will break.
Tip the bottom of the softener up a few inches
and hold until all water has drained Leave the
softener laying like this until you are ready to
use iL Plug the inlet and outlet with rags to
keep dirt, bugs, etc, out,
16