Filter
Top Products
3
Adjusting the feet
Turn the adjusting screw counterclockwise (in the
direction of A) as much as possible, before placing
the machine on a surface.
q Adjusting screw
Place the machine on a flat and level surface.
Turn the adjustable foot so the four feet firmly
contact the surface.
w Adjustable foot
e Foot
Turn the adjusting screw clockwise (in the direction B)
until it contacts the surface.
NOTE:
Make sure that the machine sits on the surface
without shaking.
q
w
e
e
e
A
B
Removing the Head Stoppers
To prevent the machine from a damage during
transportation, the machine is delivered with the
head stoppers installed on the guide bar to fix the
needle bar head.
Make sure to remove the two head stoppers on both
sides of the guide bar before operating the machine.
q Head stopper
w Guide bar
When you repack the machine for transportation,
attach the two head stopper against the metal frame
with the screws to fix the needle bar head.
NOTE:
Select the needle bar No. 3 in the Ready to Sew
mode and turn the power off then attach the
stoppers (refer to pages 26, 39) .
q
w