Filter
Top Products
14
Direct PC-Link
The MB-4 can be connected to the PC with the
USB cable included as standard accessory.
You need Digitizer MB for multi-needle software
(optional item) to operate the machine via direct
PC-link.
Connecting the Machine and PC
Start up the MB-4 and PC, and insert the type A
USB connector in to the PC.
Insert the type B USB connector into the USB port
on the machine.
q Type A USB connector
w Type B USB connector
Transfer the embroidery pattern data files between
the machine and PC by using optional Digitizer
MB for multi-needle.
After the data transfer is finished, the LCD screen
will show the Ready to Sew mode display or return
to the previous screen, depending on the setting
you have made on Digitizer MB for multi-needle.
CAUTION:
Do not turn the power switch off or disconnect the
USB cable while the data transfer is in progress.
Otherwise the data will be lost or the memory will
be damaged.
NOTE:
Refer to instruction book of optional Digitizer MB
for multi-needle for further details.
PC
M
q
w