Filter
Top Products
16
Winding the Bobbin
z Place the thread cone (spool of thread) on the rear
most spool pin.
Pass the thread through the thread guide A.
q Thread guide A
x Pass the thread through the upper hole and lower
hole in the thread guide B.
w Thread guide B
c Draw the thread to the front.
Hold the thread with both hands and pass the
thread firmly around and under the tension disk.
e Tension disk
v Pass the thread through the hole in the bobbin
from the inside.
Put the bobbin on the bobbin winder spindle.
r Hole in the bobbin
t Bobbin winder spindle
b Push the bobbin winder stopper up against the
bobbin.
y Bobbin winder stopper
n Press the bobbin winding button while holding the
thread end.
u Bobbin winder button
m Press the bobbin winder button to stop the
machine when the bobbin has wound a few layers.
Cut the thread close to the bobbin and press the
bobbin winder button again.
, When the bobbin is fully wound, the machine will
stop automatically.
Remove the bobbin from the bobbin winder
spindle.
. Cut the thread with the bobbin thread cutter.
i Bobbin thread cutter
zx
c
v
b
n
m
,
.
q
w
e
r
t
y
u
i