Filter
Top Products
– 24 –
Device Programming
This menu is used to program keypads, receivers, and relay modules, etc.
Device Address 00 is always set as an alpha keypad assigned to Partition 1 with no sounder suppression
options, and these settings cannot be changed.
From Data Field Programming mode, press #93 to display "ZONE PROG?" Press [0] repeatedly to display "DEVICE PROG?"
PROMPT
EXPLANATION
DEVICE PROG?
1=YES 0=NO 0
Press [1] to enter Device Programming.
DEVICE ADDRESS
01-30, 00=QUIT 01
The device address identifies the device to the control. Enter the 2-digit device address number to match
the device’s physical address setting (01-30).
Press [✱] to accept entry.
Select the type of addressable device as follows:
00 = device not used 03 = RF receiver (5881)
01 = alpha keypad (6139/6160) 04 = output relay module (4204)
02 = fixed-word keypad (6137/6150) 05 = voice (VIP) Module (4285/4286)
DEVICE TYPE
00
Press [✱] to accept entry.
Alpha or Fixed-Word Keypad
PROMPT
EXPLANATION
01 CONSOLE PART.
1
If you selected device type 01 (alpha keypad), or 02 (fixed-word keypad), this prompt appears. Enter the
addressable device’s default partition number (01 to maximum number of partitions programmed for system
in field 2*00). This is the primary partition for the device. Enter 9 to make this keypad a "Master" keypad for
the system.
Press [✱] to accept entry.
01 SOUND OPTION
00
Keypads can be individually programmed to suppress arm/disarm beeps, entry/exit beeps and chime mode
beeps. This helps prevent unwanted sounds from disturbing users in other areas of the premises.
Enter a number 00-03 for the keypad sounding suppression options desired for the keypad as follows:
00 = no suppression
01 = suppress arm/disarm & entry/exit beeps
02 = suppress chime mode beeps only
03 = suppress arm/disarm, entry/exit and chime mode beeps
Press [✱] to accept entry.
RF Expander
PROMPT
EXPLANATION
01 RF EXPANDER
HOUSE I 00
If you selected device type 03 (RF receiver), this prompt appears. Enter the 2-digit House ID (00-31). This
is required if you are using a wireless keypad (5827/5827BD).
Press [✱] to accept entry.
VIP Module
PROMPT
EXPLANATION
01 MODULE PART.
1
If you selected device type 05 (VIP Module) this prompt appears. Enter the partition number 1-8 in which the
module is located.
Press [✱] to accept entry.
Press 00 + [✱] to exit Menu mode.
Press ✱99 to exit Program mode.