Filter
Top Products
Enabling FIRSTVISION to Monitor Your Building Establish Gateway Communication
24 FIRSTVISION™ Installation and Operation Manual - P/N: 53034:Rev: A2 10/29/07
It is anticipated that the factory settings for a gateway may probably work for your application and
it is recommended you use them, if possible, instead of setting up new settings. If you want to
change the factory settings use the following information
How To Add a Gateway Using the Configuration Tool
The gateway can be changed here, but FIRSTVISION can monitor only one gateway.
Step 1. Start the Configuration Tool.
Step 2. Select Tools > Gateway Configuration.
Step 3. Enter the Gateway IP address.
Step 4. Click OK.
Figure 3.14 Gateway Configuration
Step 5. Close the Configuration Tool.
Step 6. You should now "Copy Your Exported Building Design to F
IRSTVISION".
NOTE: Your LAN connection must be established before you add a gateway.
NOTE: If you change the gateway IP address, you must re-export your building design to XML.
See “How to Export Your Building Design for Copying to FIRSTVISION” in ONYX®FIRSTVISION™
Configuration Tool Manual - 53035.
NOTE: The factory default Gateway IP address setting is: 192.168.0.3. If you need to change
this setting, then use the following information.