Filter
Top Products
FIRSTVISION Installation Instructions LCD Installation
14 FIRSTVISION™ Installation and Operation Manual - P/N: 53034:Rev: A2 10/29/07
Figure 2.2 FIRSTVISION Power Wiring Diagram
2.3 LCD Installation
Step 1. Install the FIRSTVISION LCD onto the enclosure’s factory installed hinges (LCD hinges on
the left).
Step 2. Connect the LCD’s power cable to the enclosure’s control board as shown in Figure 2.2 on
page 14.
Step 3. Connect the customer supplied LAN cable to the LAN port as shown in Figure 3.3 on
page 16.
Step 4. Swing the LCD closed and fasten it closed by using the 2 factory supplied black pan head
machined screws.
Step 5. Close the LCD’s glass paneled door.
Step 6. Use the factory supplied door key to lock the closed door.
Step 7. Verify the door locks and unlocks with each turn of the key.
Step 8. You are now ready to perform “Enabling F
IRSTVISION to Monitor Your Building” on
page 15.
b
a
c
k
o
f
L
C
D
d
i
s
p
l
a
y
The FIRSTVISION
enclosure is factory
assembled and wired to
install/connect the LCD.
P1
J1
LCD Power Cable
Enclosure’s Control Board
From Power Supply
Enclosure’s
Control Board
+24VDC/3A
Common GND
b
a
c
k
o
f
L
C
D
Power Cable
from LCD
!
WARNING: Electrical Connections
If power is applied to F
IRSTVISION for testing your electrical connections, you MUST shut down
FIRSTVISION’s Windows® operating system before turning off the power. See “Make Connections to
FIRSTVISION” on page 15 for instructions on using FIRSTVISION like a personal computer, and then
follow standard Windows shut-down procedures.