Filter
Top Products
2
WARNING
Hazardous voltage
can shock, burn or
cause death.
DESCRIPTION AND SPECIFICATIONS
The Model 3885 is a 2" NPT discharge,
3
⁄4" (19 mm) solids
handling, submersible effluent pump. The Model 3886 is
a 2" (50 mm) solids handling, submersible sewage pump.
The Model 3887 is a 2" flanged (standard) 3" flange
(optional) discharge, 2" (50 mm) solids handling,
submersible sewage pump.
Lifting of Pump
DO NOT LIFT, CARRY OR HANG
PUMP BY THE ELECTRICAL
CABLES. DAMAGE TO THE
ELECTRICAL CABLES CAN CAUSE
SHOCK, BURNS OR DEATH.
• Lift the pump with an adequately sized chain or cable
attached to the lifting handle (458). DO NOT damage
electrical cables while raising and lowering unit.
Sliderail System
• The OPTIONAL Goulds Model A10-20 sliderail system is
recommended for proper installation.
NOTICE: FOLLOW THE INSTALLATION AND
OPERATION INSTRUCTIONS PROVIDED
WITH THE SLIDERAIL SYSTEM.
• Installation of the sliderail system should locate the pump
opposite the influent opening, preventing stagnate areas
where solids can settle.
• The pit floor MUST be flat under the sliderail base and
have sufficient loading capacity to support the entire
weight of the assembly, including the sliderail base,
sliderail guide, pump and all assorted piping.
Piping
• Discharge piping should be no smaller than 2" (51 mm)
diameter and kept as short as possible, avoiding
unnecessary fittings to minimize friction losses.
• Install an adequately sized check valve (suitable for
handling
3
⁄4" (19 mm) solids for effluent applications and
2" (50 mm) solids for sewage applications) in the
discharge pipe to prevent backflow. Follow the check
valve manufacturer’s installation instructions.
• Install an adequately sized gate valve ABOVE the check
valve for pump, plumbing and check valve maintenance.
• To deter air locking, drill a
3
⁄16" (4.8 mm) hole, 2"
(50.8 mm) beyond the pump discharge connection.
• All piping must be adequately supported, so as not to
impart any piping strain or loads on the pump.
SAFETY INSTRUCTIONS
TO AVOID SERIOUS OR FATAL PERSONAL
INJURY OR MAJOR PROPERTY DAMAGE, READ
AND FOLLOW ALL SAFETY INSTRUCTIONS IN
MANUAL AND ON PUMP.
THIS MANUAL IS INTENDED TO ASSIST IN THE
INSTALLATION AND OPERATION OF THIS UNIT
AND MUST BE KEPT WITH THE PUMP.
This is a SAFETY ALERT SYMBOL.
When you see this symbol on the pump or
in the manual, look for one of the follow-
ing signal words and be alert to the
potential for personal injury or property
damage.
Warns of hazards that WILL cause serious
personal injury, death or major property
damage.
Warns of hazards that CAN cause serious
personal injury, death or major property
damage.
Warns of hazards that CAN cause personal
injury or property damage.
NOTICE:INDICATES SPECIAL INSTRUCTIONS
WHICH AREVERY IMPORTANT AND
MUST BE FOLLOWED.
THOROUGHLY REVIEW ALL INSTRUCTIONS
AND WARNINGS PRIOR TO PERFORMING ANY
WORK ON THIS PUMP.
MAINTAIN ALL SAFETY DECALS.
UNIT NOT DESIGNED FOR USE
WITH HAZARDOUS LIQUIDS OR
FLAMMABLE GASES. THESE
FLUIDS MAY BE PRESENT IN
CONTAINMENT AREAS.
NOTICE: INSPECT UNIT FOR DAMAGE AND
REPORT ALL DAMAGE TO THE CARRIER
OR DEALER IMMEDIATELY.
DANGER
WARNING
CAUTION
WARNING
Hazardous fluids
can cause fire,
burns or death.