Filter
Top Products
01-03 19 33606 Rev D
BUILDER'S CHOICE SERIES INSTALLATION INSTRUCTIONS
1. Turn off all wall switches to the appliance or remote.
2. Open the control access panel.
3 Turn gas line to CLOSED. Wait 5 minutes to clear
out any gas. Then smell for gas, including near the
floor. If you smell gas, STOP! Follow B in the safety
information above on this label. If you dont smell
gas, go to the next step.
4 Turn gas line valve to OPEN.
5 Turn pilot knob clockwise to OFF (knob may have to
be depressed to pass the PILOT position).
6 Locate pilot assembly inside appliance.
7 Locate red ignitor button in the bottom of the appli-
ance.
8 Turn pilot knob to PILOT and push in.
9. Continue to hold in pilot knob and push the red igni-
tor button 12-15 times until small blue pilot flame
appears.
10. Continue to hold in pilot knob for approximately one
minute. Pilot should remain lit. If pilot goes out, wait 5
minutes and repeat Steps 4-9.
11 Release and turn the knob counterclockwise to ON.
Turn the wall switch to ON to light the main burner.
Do not light by hand!
12. If the appliance will not operate, follow the instruc-
tions To Turn Off Gas To Appliance and call your
service technician or gas supplier.
K. LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electric switch; do not use any phone
in your building.
Immediately call your gas supplier from a neighbors
phone. Follow the suppliers instructions.
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn knob. Never use
tools. If the knob will not push in or turn by hand, dont
try to repair it; call a qualified service technician. Force
or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which as been
under water.
WARNING!
If you do not follow these instructions exactly, a fire or explosion may result causing property damage, per-
sonal injury or loss of life.
LIGHTING INSTRUCTIONS
STOP! Read the safety information above on this label!
TO TURN OFF THE GAS TO THE APPLIANCE
1. Turn off the wall switch or set thermostat to lowest
setting.
2. Close the control access panel.
3. Turn gas line to CLOSED position. Do not force.
4. Close control access panel.