Filter
Top Products
Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/1120
Vertical Termination Cap
Section 10
Storm Collar
Section 10
Vent pipe penetrates roof,
preverably without affecting
roof rafters.
Section 8
Attic insulation shield (not shown)
must be used here to keep insulation
away from vent pipe if attic is insulated.
Section 8
Framing headed off
in ceiling joists
Section 8
Hearth Extension
(not required)
Gas Line
Section 12
Framing/Steel Stud Assy
Section 5
Vent Pipe
Sections 7, 8, 10
Ceiling firestop
on floor of attic
Section 8
Noncombustible roof
flashing maintains minimum
clearance around pipe
Section 10
A. Typical Appliance System
NOTICE: Illustrations and photos refl ect typical installations and are for design purposes only. Illustrations/diagrams are not
drawn to scale. Actual product may vary from pictures in manual
Figure 4.1 Typical System
4
4
Getting Started
Installer Guide
Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the
following actions:
• Installation and use of any damaged appliance or vent system component.
• Modifi cation of the appliance or vent system.
• Installation other than as instructed by Hearth & Home Technologies.
• Improper positioning of the decorative steel log assembly or the glass door.
• Installation and/or use of any component part not approved by Hearth & Home
Technologies.
Any such action may cause a fi re hazard.