Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/1118
Clean Porcelain Panels
Frequency: As needed
By: Qualifi ed Service Technician
Tools needed: Protective gloves, phillips screwdriver
• Disconnect power to fi replace.
• Remove the “L” plates and inner surround frame (see
surround install). This will make the valve compartment
and glass accessible. (Refer to Section 3.A. Glass
Cleaning.)
• Remove glass rock, set aside.
Remove
Plates
Figure 3.8 Remove Three Plates
Note: Mark and note burner tube locations.
They are not interchangeable (Figure 3.7).
Figure 3.9 Remove Outside Burner Tubes
• Remove three outside burner tubes by removing two
screws on each tube. See Figure 3.9.
• Remove three cover plates by removing two screws from
each plate. See Figure 3.8.
RH Burner Tube
LH Burner Tube
Back Burner Tube
1 1/4 in.
1 7/8 in.
2 3/8 in.
Back
LH
RH
Figure 3.7 Burner Tube ID