Filter
Top Products
6
PF100
3. Place the filter frame panel inside the bottom
and inside the solid panel corner. See Fig. 6 for corner
detail. Make sure that the filter opening is up.See Fig. 5
Hold the filter panel to the solid panel with a Tek screw
in the middle hole of the solid panel, and one in the bot-
tom middle hole under the filter opening.
NOTE: Do not put any screws into any of the top
holes at this time.
4. Place the remaining panel, (in this case the
blower access panel) in the bottom panel and into the
corner of the solid panel. See Fig. 7. Make sure that the
panel is in the upright position. There are no cover mount-
ing holes in the bottom edge of this panel. Hold the panel
into place with one Tek screw in the middle hole of the
solid panel and one in the bottom middle hole of the
blower access panel.
Fig. 5
Fig. 6
Fig. 7
Filter Frame Panel
Open Side Panel
Assembling Filter Box, Cont’d
Filter opening must be up
Assembly