Filter
Top Products
Temp Dial
Mode Selector
1 Ture Mode Selector to OFF.
2 Use shaker handle to clean the heat exchanger tubes.**
3 Scrape the air holes in the burnpot.**
4 Fill the hopper with pellets.
5 Turn Feed Adjuster to “Test”.*
6 Check the Combustion Blower and Feeder Motor for operation.*
7 Turn Feed Adjuster back to the #4 setting.
8 Turn the Wall Control to the desired temperature.
9 Turn all of the Furnace Control knobs to the settings shown.*
10 Flip the Auto-Light switch up.*
The furnace will ignite if the temperature in the room is less than the
temperature set on the Wall Control.
*See the section on Operation for information
about Manual Lighting and Emergency Power.
**See the section on Maintenance for more details
about cleaning.
Wall Control
“Test”
Quick Reference ( Auto-Light )