Filter
Top Products
9
Hopper right, ue left
Hopper left, ue right
Assembly
Fig. 1
Fig. 2
Feeder
Begin assembly by sliding the pusher block with the adjuster rod from the front through the slot shown
in Fig. 1. Be sure the pusher block is turned with the bolt hole to feed indicator side. Next, hold pusher block
in the most rearward position and slide the adjuster tube over the adjuster rod until it bottoms out on the pusher
block. Thread the adjuster, then the wing nut on the end of the adjuster rod.
Put gasket around the opening on the adapter plate. Slide the feeder through the plate and bolt together
with two 5/16 x 3/4” bolts. Next, install the grate holder.
The grate is composed of four pieces: the grate holder,
(2) grate inserts, and rebrick angle. The rebrick angle
is bolted to the grate holder with (2) 3/8” x 1 1/4” bolts.
Before installing the grate holder, 3/8” round gasket must
be checked in the groove on the bottom side of the grate
holder, as shown in g. 4. Check to be sure the gasket has
not been damaged. Locate the ange at the rear of the grate
holder into the slot on the feeder as shown at left. Bolt
the front end down snug with the 1/4” x 20 allen bolt and
nut provided. The rear end will be
locked in place by the ange.
-