Hamilton Home Products DGH30 - 75 Gas Heater User Manual


 
FIGURE 8 DGH WIRING DIAGRAM BEFORE OPERATING UNIT HEATER
Follow these on-site pre-operational procedures
before putting unit heater into operation:
1. Turn off power supply.
2. Check all clearances.
3. Make sure fan is not contacting casing when
blade is spun by hand.
4. Check to make sure deflector blades are at
a 30° minimum angle from the horizontal.
5. Make sure all electrical connections are
secure.
6. Check for gas leaks.
LIGHTING / OPERATING INSTRUCTIONS
FOR YOUR SAFETY, READ BEFORE OPERATING
If you do not follow these instructions exactly
a fire or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance does not have a pilot. It is
equipped with an ignition device which auto-
matically lights the burner. DO NOT
TRY TO
LIGHT THE BURNER BY HAND.
B. BEFORE OPERATING, smell around the area
where the appliance is installed for gas. Be sure
to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
* Do not try to light any appliance.
* Do not touch any electric switch; do not use
any phone in your building.
* Immediately call you gas supplier from a
neighbors phone. Follow the gas supplier's
instructions.
* If you cannot reach your gas supplier, call
the fire department.
WARNING
PROPER POLARITY IS REQUIRED
14