Filter
Top Products
2 | Hamilton Beach Owner’s Manual
Hamilton Beach Owner’s Manual | 3
MODEL: SA-HB-40-DB-CERT Water Softener
Operating Temperature: 34
o
–120
o
F
Operating Pressure: 20–60 psi (#5 injector); 61-120 psi (#4 injector)
Voltage: 110V 60 cycles
Rated Service Flow: 15.2 GPM @ 15 psi
Rated Softening Capacity: 14.2 @ 3.0 (#5 injector)
(Kilograins / Pounds of Salt) 24 @ 7.5, 37.0 @ 15 (#4 injector)
Max Flow Rate to Drain: 4.0 GPM
Amount of High Capacity Resin: 1.25 ft
3
Rated Efficiency: 4,720 grains @ 3.0 lbs
**Observe all state and local plumbing codes.
**This softener conforms to NSF/ANSI 44 for the specifically claimed
performance.
**The efficiency of the softener is valid only at the stated salt
dosage.
Manufactured By:
R&M Manufacturing
28 South 1550 West
Lindon UT 84042-1617
(801) 785-5557
pn: LBL-HB-40-CERT
CAUTION: Do NOT use with water that
is microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system.
pn: LBL-HB-48-CERT
MODEL: SA-HB-48-CERT Water Softener
Operating Temperature: 34
o
–120
o
F
Operating Pressure: 20–60 psi (#5 injector); 61-120 psi (#4 injector)
Voltage: 110V 60 cycles
Rated Service Flow: 18 GPM @ 35 psi inlet
Rated Softening Capacity: 15.1 @ 3.6 (#5 injector)
(Kilograins / Pounds of Salt) 26.0 @ 9.0, 39.7 @ 18 (#4 injector)
Max Flow Rate to Drain: 3.5 GPM
Amount of High Capacity Resin: 1.5 ft
3
Rated Efficiency: 4,210 grains @ 3.6 lbs
**Observe all state and local plumbing codes.
**This softener conforms to NSF/ANSI 44 for the specifically claimed
performance.
**The efficiency of the softener is valid only at the stated salt dosage.
Manufactured By:
R&M Manufacturing
28 South 1550 West
Lindon UT 84042-1617
(801) 785-5557
CAUTION: Do NOT use with water that
is microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system.
See pages 8 through 11 for:
• pre-installation checklist
• installation instructions
• start-up directions