GSW 5065 Water Heater User Manual


 
FOR YOUR SAFETY READ BEFORE
OPERATING
POUR VOTRE SÉCURITÉ, LISEZ AVANT
DE METTRE EN MARCHE
OPERATING INSTRUCTIONS INSTRUCTIONS DE MISE EN MARCHE
TO TURN OFF GAS TO APPLIANCE COMMENT COUPER L'ADMISSION DE
GAZ DE L'APPAREIL
WARNING: If you do not follow these instructions exactly, a
fire or explosion may result causing property damage, person-
al injury or loss of life.
ATTENTION: Quiconque ne respecte pas à la lettre les
instructions dans la présente notice risque de déclencher un
incendie ou une explosion entraînant des dommages, des
blessures ou la mort.
A. This appliance does not have a pilot. It is equipped with an
ignition device which automatically lights the burner. Do not
try to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electric switch; do not use any phone
in your building.
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
switch. Never use tools. If the switch will not push in or turn
by hand, do not try to repair it, call a qualified service tech-
nician. Force or attempted repair may result in a fire or
explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
A. Cet appareil ne comporte pas de veilleuse. Il est muni d'un
dispositif d'allumage qui allume automatiquement la
brûleur. Ne tentez pas d'allumer le brûleur manuellement.
B. AVANT DE FAIRE FONCTIONNER, reniflez tout autour de
l'appareil pour déceler une odeur de gaz. Reniflez près du
plancher, car certains gaz sont plus lourds que l'air et peu-
vent s’accumuler au niveau du sol.
QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:
Ne pas tenter d’allumer d’appareil.
Ne touchez à aucun interrupteur; ne pas vous servir des
téléphones se trouvant dans le bâtiment.
Appelez immédiatement votre fournisseur de gaz depuis
un voisin. Suivez les instructions du fournisseur.
Si vous ne pouvez rejoindre le fournisseur, appelez le
service des incendies.
C. Ne poussez ou tournez le manette d’admission du gaz qu’à
la main; ne jamais utiliser d'outil. Si la manette reste
coincée, ne pas tenter de le réparer; appelez un technicien
qualifié. Le fait de forcer la manette ou de la réparer peut
déclencher une explosion ou un incendie.
D. N’utilisez pas cet appareil s’il a été plongé dans l’eau, même
partiellement. Faites inspecter l’appareil par un technicien
qualifié et remplacez toute partie du système de contrôle et
toute commande qui ont été de plongés dans l’eau.
1. STOP! Read the safety information above (to the left) on
this label.
2. Set the thermostat to the lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which
automatically lights the burner. Do not try to light the burn-
er by hand.
5. Press gas control switch. It will automatically turn to
"OFF."
6. Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you then smell gas, STOP!
Follow "B" in the safety information above (to the left) on
this label. If you do not smell gas, proceed to the next step.
7. Turn gas control switch counterclockwise to "ON".
8. Turn on all electric power to the appliance.
9. Set thermostat dial to
desired setting.
10. If the appliance will not
operate, follow the
instructions “To Turn
Off Gas To Appliance”
and call your service
technician or gas sup-
plier.
1. ARRETÈZ! Lisez les instructions de sécurité sur la portion
supérieure (à gauche) de cette étiquette.
2. Réglez le thermostat à la température la plus basse.
3. Coupez l’alimentation électrique de l'appareil.
4. Le present appareil est muni dispositif d'allumage qui
allume automatiquement la brûleur. NE PAS TENTEZ D'AL-
LUMER LA BRÛLEUR MANUELLEMENT.
5. Tourner le bouton du regulateur de gaz vers la droite
jusqu'a la position "OFF".
6. Attendre cinq (5) minutes pour laisser échapper tout le gaz.
Reniflez tout autour de l’appareil, y compris près du
plancher, pour déceler une odeur de gaz. Si vous sentez
une odeur du gaz, ARRETEZ! Passez à l’étape “B” des
instructions de sécurité sur la portion supérieure (à
gauche) de cette étiquette. S’il n’y a pas d’odeur de gaz,
passez à l'étape suivante.
7. Tourner le bouton du regulateur de gaz vers la
gauche jusqu'a la position "ON".
8. Mettez l'appereil sous tension.
9. Réglez le thermostat à la température désirée.
10. Si l'appareil ne se met pas en marche, suivez les
instructions intitulées “Comment Couper
L’admission De Gaz De L’appareil” et appelez un
technicien qualifié ou le fournisseur de gaz.
1. Set the thermostat dial to lowest setting.
2. Turn off all electric power to the appliance if service is to
be performed.
3. Press gas control switch. It will automatically turn to
"OFF."
1. Réglez le thermostat à la température la plus bas.
2. Coupez l’alimentation électrique de l'appareil s’il faut
procéder à l’entretien.
3. Tourner le bouton du regulateur de gaz vers la droite a la
position "OFF".
GAS CONTROL
SWITCH SHOWN
IN "ON"
POSITION.
BOUTON DU
REGULATEUR
DE GAZ. EN
POSITION "ON"
TEMPERATURE
DIAL. CADRAN DE
TEMPERATURE
IV) LIGHTING & OPERATING INSTRUCTIONS
– 20 –