Filter
Top Products
Concord 4 Series Security Systems
26
3. To schedule:
Latchkey Opening, press
# when the touchpad displays “LATCHKEY OPENING” or
“LATCH OPEN.”
Or, press
B until the touchpad displays “LATCHKEY CLOSING” or “LATCH CLOSE,”
then press
#.
If you want a page to be sent every time Latchkey-designated user codes arm or disarm the
system, apply the same time schedules under Latchkey Opening and Latchkey Closing.
4. The touchpad displays the first available time schedule.
5. Enter
2 + # to assign the time schedule to the event.
1 + # to make the time schedule inactive for the event.
6. Press
# to secure your choice.
7. Press
B to go to the next schedule and repeat step 5.
8. When you’ve finished attaching the desired time schedules, press * + 00 + # to exit the pro-
gramming menus.
Applying the Latchkey Modifier
The Latchkey modifier (6) is pressed after the arming keypress sequence.
Applying the Latchkey modifier from a touchpad:
1. At any touchpad, press 2 3 + CODE + 6.
The touchpad displays, “LATCHKEY PAGER ON” or “PAGER ON.”
Note
6 must be pressed within 5
seconds of arming. If Quick
Arm feature is on, an access
code is not required. See
“Quick Arm” for more infor-
mation.
To apply the Latchkey modifier using a keychain touchpad:
Press the Lock button when the system is armed to level 3—AWAY.
Notify by
Exception
The Notify by Exception feature allows programmed pager holders and/or the central station to
be notified when arming or disarming occurs outside of specified time schedules.
Here are two specific examples of how the Notify by Exception feature might be used in a busi-
ness setting:
• Every morning you’d like to be notified if your business is disarmed after its normal opening
time.
• Every evening you’d like to be notified if your business is armed before its normal closing
time.
Page In the Event of...
You can set up the Notify by Exception feature to page in the following instances:
• Send a page if the system is disarmed before the Opening time schedule begins or after the
Opening time schedule has ended. (Exception Opening)
• Send a page if the system is armed before the Closing time schedule begins or after the Clos-
ing time schedule has ended. (Exception Closing)
Who Will Be Paged?
Your system can call up to 5 different pager numbers to report an Open Exception and/or Closed
Exception. You can request that the central station receive these two reports as well.
Refer to “Appendix A: User Sheets” to see which pagers have been set up to receive a page for
this feature. Contact the installer if you would like to turn the Notify by Exception feature on or
off for any programmed pager or the central station.