Stovax PR0731 Electric Heater User Manual


  Open as PDF
of 26
 
4
USER INSTRUCTIONS
1. GENERAL
1.1 A competent person must carry out installation and
servicing.
1.2 In all correspondence, please quote the appliance type and
serial number, which can be found on the data badge
located on a plate under the control valve.
1.3 Ensure that curtains are not positioned above the appliance
and there is at least 300mm between the sides of the
appliance and any curtains.
1.4 If any cracks appear in the glass panel do not use the
appliance until the panel has been replaced.
1.5 If, for any reason, the flue has to be removed from the
appliance, the seals must be replaced in the inner spigot.
1.6 Do not obstruct the flue terminal in any way, i.e. by
planting flowers, trees, shrubs etc in the near vicinity, or by
leaning objects up against the terminal guard.
1.7 Do not use a garden sprinkler or hose near the terminal.
1.8 Do not stand or place objects on the terminal guard as this
will deform it.
This product is guaranteed for 2 years from the date of
installation, as set out in the terms and conditions of sale
between Gazco and your local Gazco dealer. Please consult
with your local Gazco dealer if you have any questions. In
all correspondence always quote the Model Number and
Serial Number.
2. LIGHTING THE LINEA
There are two ways of lighting the Linea:
• bythermostaticremotecontrol,see2A
•usingthefire’stouchpad,see2B
2A - THERMOSTATIC and TIMER REMOTE CONTROL
1
AR1883
Turning the Linea On
Your remote can control the gas fire from pilot ignition
through to shut down.
To turn the fire on:
• PresstheOFFbuttonandtheUParrowsimultaneously
The pilot and main burner ignite and the remote is now in
ManualMode.In‘MANUALMODE’youcan:
• turnonthemainburner
• regulatetheflamefromlowtohighandback
• turnofftheburnerleavingjustthepilotburning
 In‘TEMPMODE’youcan:
• settheroomtemperaturesothethermostatinthe
remote automatically maintains that temperature
In‘TIMERMODE’thefire:
• turnsonandoffaccordingtothesettimeperiods
• automaticallyregulatestheroomtemperatureduringthe
set periods
NOTE: Wh E N Op E ra T i N g T h E firE i N TE m p Or Ti m Er m O d E ,
T hE pi l O T r E m a i N s li T aN d T hE firE T h E N auTOmaTically
sW iT chE s O N aT p r O g r a m m E d T i mE s TO b r iN g T h E r O O m TO
T hE sET TEmpEraTurE W h ET h E r O r N OT y O u arE iN T h E r OO m .
NEVER LEAVE ANY COMBUSTIBLE MATERIALS WITHIN 1
METRE OF THE FRONT OF THE APPLIANCE.
2.1 SWITCHING BETWEEN MODES
• PresstheSETbuttontochangetoManualOperation
• PressagaintochangetoTemperatureMode
• Keeppressingtorunthroughalloperatingmodes.These
are:
• MAN
• DAY TEMP
• NIGHTTEMP
• TIMER
and back to MAN
NOTE: MAN mode can also be reached by pressing
either the UP or DOWN arrow
2.2 MAN MODE
•PressboththeUParrowandimmediatelypresstheOFF
button to light the appliance. You hear a click as the fire
begins the ignition process , (up to 30 seconds)
• PresstheOFFbuttontoturntheapplianceoff
INCREASING TEMPERATURE
• PresstheUParrowoncetoincreaseflameheightone
stage
• PressandholdtheUParrowtoincreasetomaximum
DECREASING TEMPERATURE
• PresstheDOWNarrowoncetodecreaseflameheight
one stage
• PressandholdtheDOWNarrowtodecreaseto
minimum
Atthelowestpointthefiregoesto‘standbymode’(only
pilot lit)
NOTE: While pressing a button a symbol indicating
transmission appears on the display. The receiver
confirms transmission with an acoustic signal.
 previous next