Stovax PR0731 Electric Heater User Manual


  Open as PDF
of 26
 
appliance. Note the orientation of the injector on the pipe.
10.7 Reassemble in reverse order and check for gas leaks.
11. CONTROL BOX
11.1 Remove the lower panel, Diagram 6
11.2 Press on/off switch retaining clips in and pop put the switch.
Turn the switch to pass it through the retaining bracket.
11.3 Remove the two screws holding the control box to the
bracket. Slide the control box to the right and remove from
the bracket.
11.4 •Removethetwothermocurrentcablesbyremoving
the two screws, Diagram 15
•Removetheeightloomwirefromthecontrolbox,
Diagram 15
15
AR1915
Thermo current
cables
Eight wire cable
Touchpad
extension
cable
Battery
extension
cable
• Removethebatteryextensioncable,Diagram15
• Removethetouchpadextensioncable,Diagram15
The control box can now be replaced.
11.5 After replacing the control box you may need to reprogram
the handset:
• Pressandholdtheresetbuttononthecontrolboxuntil
you hear two signals. After the second longer signal:
• Releasetheresetbuttonandwithin20
seconds
 -PresstheDOWNbuttononthehandsetuntil
you hear an additional long signal
confirming the new code
• RefertoSection4oftheInstallation Instructions to set
new code
21
SERVICING INSTRUCTIONS
REPLACING PARTS
12
AR1338
C
C
C
C
C
C
C
C
C
10.3 Remove the main burner as described in section 2.
10.4 Remove the locknut from the injector. See diagram 13
13
AR1345
10.5 Remove the feed pipe from the gas valve. See diagram 14.
14
AR1994
10.6 Remove the feed pipe with the injector attached from the
 previous next