Stovax PR0731 Electric Heater User Manual


  Open as PDF
of 26
 
20
8
AR1994
C
7.3 Undo the thermocouple nut in the back of the pilot burner
by half a turn. This will release the thermocouple.
7.4 Whenreplacingthethermocoupleintothepilotburner
ensure the component is pushed fully into the hole. There is
a stop on the thermocouple to set the height.
7.5 Lock the retaining nut just enough to grip the
thermocouple.
7.6 Replace the lower panel.
8. IGNITION LEAD
8.1 Remove the lower panel and pull the ignition lead off the
electrode.
8.2 Release the wires from the central white clip and carefully
cut the cable ties. This will release the ignition lead. See
diagram 9, Arrow B.
9
AR1994
B
8.3 Replace with a new lead, replace with new cable ties and
fit the wires back into the clip.
8.4 Re-fitthepanelandensurenowiresaretrapped.
9. MAGNETIC SAFETY VALVE
9.1 • Turnthegasoffattheisolationdevice.
9.2 • Removethelowerpanel,Diagram6
9.3 • Undothethermocouplefromtheinterrupterblockand
remove the two thermo current cables
• Unscrewtheinterrupterblockfromthebackofthevalve.
Diagram 10
10
AR1994
9.4 Support the valve and remove the magnetic valve retaining
nut, Diagram 11
11
AR1994
9.5 Reassemble in reverse order and check for gas leaks.
10. MAIN INJECTOR
10.1 Remove the lower panel. See diagram 6.
10.2 Remove the glass frame. See diagram 12 arrow C.
SERVICING INSTRUCTIONS
REPLACING PARTS
 previous next