Stovax PR0731 Electric Heater User Manual


  Open as PDF
of 26
 
14
INSTALLATION INSTRUCTIONS
INSTALLATION
• automaticallyregulatestheroomtemperatureduringthe
set periods
TOUCH PAD CONTROL
10
AR1885
• PresstheON-OFFbuttontolighttheappliance,(upto
30 seconds)
• PresstheUPbuttontoincreasetheflameheight
• PresstheDOWNbuttontodecreasetheflameheight.At
thelowestpointitgoesto‘standbymode’,(onlypilot
lit)
• PresstheON-OFFbuttontoturntheapplianceoff
4. REPROGRAMMING HANDSET/CONTROL
BOX
• Removethebatterycoverfromthehandsettoseethe
four DIP switches, Diagram 11
11
AR1935
2.15 Replace the glass frame; ensure the top of the frame is
hooked on the tabs at the top of the appliance and replace
the nine screws with the three longest screws used in the
bottom fixing holes. Tighten from the top down.
HAVE YOU PURGED THE GAS SUPPLY?
2.16 Connect the gas supply to the isolation device using 8mm
pipe. Connect a suitable pressure gauge to the test point
and turn on the gas supply and check for leaks.
2.17 Light the appliance and set it to maximum. Check the
pressure corresponds to the data badge. Turn the gas off
and replace the test point screw. Turn the gas on and check
the screw for leaks.
THE YELLOW FLAMES WILL APPEAR WHEN THE FIRE
HAS GAINED SUFFICIENT HEAT - TYPICALLY 20
MINUTES.
3. LIGHTING THE LINEA
Note: The Emergency Shut Off switch must be in the ON
position, refer to Section 2, User Instructions.
There are two ways of lighting the Linea:
• bythermostaticremotecontrol
• usingthefire’stouchpad
THERMOSTATIC REMOTE CONTROL
9
AR1883
Thisremotecontrolsthegasfire.In‘MANUALMODE’youcan:
• turnonthemainburner
• regulatetheflamefromlowtohighandback
• turnofftheburner
 In‘TEMPMODE’youcan:
• settheroomtemperaturesothefireautomatically
maintains that temperature
In‘TIMERMODE’thefire:
• turnsonandoffaccordingtothesettimeperiods
 previous next