Filter
Top Products
www.fmiproducts.com
125160-01A 29
Refractory Firebrick lining must be installed. There
are two options. You can obtain pre-fabricated Modu-
lar Firebrick Liner from FMI PRODUCTS, LLC (see
Accessories on page 33) or custom rebrick lining
can be installed.
MODULAR FIREBRICK LINING
If using FMI PRODUCTS, LLC Module Firebrick Lin-
ers, simply use an extra bag of the mortar we sup-
ply. Install Hearth panel rst, rear panel next and side
panels last. Consider if brackets for grates will be
required also if pre-drilling is required for gas lines,
electrical or if the outside combustion air kit is to be
installed. The rear Liner Panel is straight from the
bottom to the top front edge of the Downdraft Divert-
FIREBRICK INSTALLATION
Area behind
Rear Firebrick
Liner Panel can
remain empty
Figure 48 - Postion of Rear Panel
er edge. The space behind does not have to be lled
(Figure 48).
CUSTOM FIREBRICK LINING
Custom Firebrick lining is can be obtained by FMI
PRODUCTS, LLC. If a custom rebrick pattern is
desired, it is required that the masonry re rated
bricks be a minimum of 1⅛" thick. The pattern for the
rebrick lining is exclusively your choice. Before you
install the lining, remember to consider any holes
your contractor may need to drill for gas, electrical
or combustion air kit access holes.
Please use a certied mason to lay-in the brick. He
will follow the proper instructions from the replace
liner manufacturer and also understand the type of
adhesive or cement he is to use.
Make sure the replace is installed with the nished
rebrick oor of the replace so that it is at least 11"
above the combustible oor system.
Disclaimer: FMI PRODUCTS, LLC wishes to ex-
press that as the manufacturer of the Grand Merid-
ian Fireplaces, they cannot take any liability or re-
sponsibility for the way the rebrick or the rebrick
mortar performs. It is not unusual in the course of
the life of the rebrick, or the rebrick mortar, for
heat stress cracks to appear. FMI PRODUCTS, LLC
cannot be responsible for this and other wear and
tear to the rebrick and mortar.