Filter
Top Products
- 4 -
Quick Reference
The following table lists the “Quick Commands” available with this control.
Key Description Keypads Comments
# 1 Quick Arm - If system is ready All keypads Allows you to arm the system without requiring your user code. User
code is always needed to disarm the system, though.
# 2
Force Arm - bypasses faulted
zones
All keypads Allows you arm the system even if some zones are faulted. These
zones will be automatically bypassed and will be unprotected.
Bypass
zone
Quick Bypass - All keypads If not enabled requires user code with authority 1,2 or 3
# 3
Set Time All keypads May require user code
# 4
Zone Dir LCD only Mode terminates after last enabled zone
# 50
Quick Help LCD only
# 51
Show Time LCD only May also require code
# 52
Show Auto LCD only May also require code
# 53
User log view LCD only Also, needs user code with authority level 1 or 2
# 54
Set Auto Time of current part. All keypads by partition, need user code
# 55
Display Firmware Version LCD only
# 56
Display Key Fob Low Batteries. All keypads
# 57
Door Strike All keypads May require certain user code
# 58
Change/View Pager number All keypads For keypad partition, only LCD shows phone number
# 6
Display/Toggle Chime Mode All keypads LCD displays current state first, then offers to toggle. All others just
toggle the state.
# 7
Assign user to other partitions All keypads Need user Auth. Of 1 or 2, Digit 4 (P) enables user to page
Paging must be enabled and turned on.
# 8
User Page Toggle All keypads Toggles if users should send page for O/C by partition
# 9
User On-line All keypads Connects to downloader while on line, disconnects home phone.
# 0
Multi-Part All keypads LCD displays current enables, 1,2,3,P - P=