Filter
Top Products
- 16 -
User Codes
TO ADD OR CHANGE A USER CODE
Users can be added or changed directly at the keypad. Your system can
have up to 64 different user codes, with each assigned to one of four
authority levels and to a primary partition. The authority level determines
the functions that user can perform. In addition, your system can be set up
for 4-digit or 6-digit user codes. Ask your installer which type of user codes
is used in your system.
To add or change a user code, press the following:
Master User Code User ID (01-64) New User Code Auth. Level
CODE nn [1-4]
Authority Levels
Level Functions Allowed
1 Primary Master, access all partitions, can view log and set time, assign other user codes, all
system functions
2 Secondary Master, same as primary master except cannot change the primary master’s code
3 User, cannot assign code and cannot bypass zones
4 Limited user, same as level 3, except can disarm the system only if it was armed by another
user with level 4 authority (cannot disarm if armed with user of higher authority level).
Assigning Partitions to Users
When a user code is assigned, that user is automatically allowed to perform
system functions in the partition in which the user’s code is assigned. You
can also allow users to access other partitions and turn on open/close
reporting to a pager by using the #7 command as follows:
[#] [7] [master code] [user no.] [1, 2, 3, or 4]
where: master code = user with authority level 1 or 2
user no. = the user that will be assigned access to other partitions
1, 2, 3, or 4 = enter the partition(s) 1-3 you want this user to have access to
enter 4 if you want this user to send open/close reports to a pager
TO DELETE A USER CODE
To delete a user, press the Code button followed by the 4-digit master user
code. Enter the the user number, then press [∗] to delete. For example, to
delete user 3, do the following:
Master User Code User ID ∗ to delete
CODE 03 [∗∗]
NOTE: User no. 1, the master user, cannot be deleted but it can be changed
using the ADD OR CHANGE user procedure.