Filter
Top Products
- 11 -
Turning The System On (cont)
Determine which zone or zones are not ready, resolve the problem, and
turn the system on normally. If the problem cannot be resolved, you may
bypass the zone that is not ready. Bypassing should only be done if the
problem on the zone cannot be resolved, OR if you intentionally wish to
leave the zone off. For example, you would leave the zone off if you plan to
keep the window open for ventilation. Zones that are bypassed are not
protected when the system is on. See Bypass on the following page for a
description of the procedure.
TO TURN THE SYSTEM ON AND STAY INSIDE
To turn the perimeter portion of your burglar alarm on and move around
freely inside the premises, use the STAY mode.
Check to make sure the system is ready. When it is ready, press:
STAY followed by your user code.
When the system has been turned on successfully, the On/Off (ARM) light
and the following will display:
LCD Keypad:
ON: STAY
PART 1
Fixed-Glass Keypad:
STAY
LED Keypad:
Arm and Stay LEDs lit
REMEMBER: You must turn the system off if you want to open the door or
leave the premises after the exit time has passed.
TO TURN THE SYSTEM ON IN INSTANT MODE AND STAY INSIDE
In INSTANT STAY mode, the perimeter portion of your burglar alarm
system is on but the time delays are eliminated from your normal
entry/exit door(s). All interior protection is off, so you are free to move
around inside.
Check to make sure the system is READY. When it is ready, press:
INSTANT followed by
STAY followed by your user code.
When the system has been turned on successfully, the On/Off (ARM) light,
the INSTANT light, and the STAY light will all be on, and the following will
display:
LCD Keypad:
ON: STAY / INS
PART 1
Fixed-Glass Keypad:
STAY
INSTANT
LED Keypad:
Armed, Stay, and Instant
LEDs lit