Filter
Top Products
- 21 -
Using a Pager
If programmed, the system can send messages to a pager. The messages
display as follows:
ACCT E XXX
where:
"ACCT" = the 4-digit central station no. 2 account number.
"E" = is the event code. There are 4 event types: alarms, troubles,
openings, and closings. These event codes are as follows:
Openings = 0, Closings = 1, Alarm or Trouble = 9
"XXX" = the zone (01-48) or user (1-64) designation, depending on the
event
If multiple events occur, the signal for the highest-priority event is sent first.
Events ranked from highest to lowest priority are alarms, trouble, open, and
close.
CHANGING THE PAGER PHONE NUMBER (FOLLOW-ME)
You can change your pager follow-me phone number as follows if your
installer enabled this feature:
1. Access pager number programming by pressing in sequence the [#], [5],
and [8] keys. An acknowledgement tone sounds to indicate pager
number programming has been accessed.
The # [5], [8] command is accessible only while the system is disarmed and
the dialer, dialer delay, and bell are not active.
In pager phone number programming mode, only the alpha keypad provides
visual display the of the numbers already programmed or numbers that are being
changed. The LED and fixed-glass style keypads provide no visual keypad
display of these numbers.
2. Enter your new pager phone number. Your new pager phone number
may consist of up to 16 characters (1-9, 0). It may be necessary to add
time to allow the pager to answer before dialing your pager number. To
enter a 2-second pause, press the [Code] key. (Entering a 2-second