Filter
Top Products
- 22 -
pause is optional and is not required to enter your pager phone
number.) If the [Code] key was pressed, it counts as one character. The
keypad will emit a single acknowledgement chirp as each number is
pressed.
3. Press the [#] key after you have made your pager phone number
changes. Pressing the [#] key saves your new pager number and nulls
out the remaining locations. An acknowledgement tone sounds.
To exit without saving changes, press the [T] key to exit pager phone
number programming. An acknowledgement tone sounds to indicate pager
number programming has been exited.
If you press the [T] key without first pressing the [#] key to save your new pager
phone number, the system exits the pager phone number programming mode
without saving the changes.
If no key is pressed within 10 seconds, the pager phone number programming
mode times out and exits automatically without saving any information entered.
TURN PAGER REPORTING ON/OFF FOR THE PARTITION
You can turn off the open/close reporting feature for a partition by
pressing
[#] [8]. To turn reporting back on, simply press [#] [8] again.
TURN PAGER REPORTING ON/OFF FOR A USER
You can turn on/off the open.close reporting feature for a user by doing the
following :
[#] [7] [master code] [user number] [4]